1 Shot on a moto helmet?

[cdsgrafix]

Any special procedure for using 1 Shot on a hlemet? I was asked to pinstripe flames on a black half skull. do I need to just preclean the heck out of it? Will it stick?
Cory

[Mike Adams]

Yes Cory, all that is needed is a god precleaning.

God luck.

[ratroder54]

i would clean with Dawn, dish washer, wipe with wax and greas remover, and start pulling some lines.

[Stripe57]

You might want to go over it with a damp cloth after you wax and grease it. Not for the sake of cleaning but to kill any static that you charged up while doing all that wiping. Use denatured alcohol to wipe off any booboos. It too will kill static, where as a dry wrag sometimes will create static.

[Mike Adams]

windex and water mixed 50/50 seems to work good for an antistatic wash as well.

[SeanOzz]

that would need no clear i assume when done?

you could reduce and spray a job if say someone just wanted to add a name in graffitti letters ontop a pre exsisting job?